|
Plastic Bushing For Steel Studs
APPLICATION:
- For use on steel stud to position and protect wire insulation from abrasion. Use with power cabling or low voltage datacom, video, and voice cabling.
- Bushing allows smooth wire pulling and positioning in accordance with NEC Article 300-4(d).
- For all pre-punched shaped holes and field punched holes.
INSTALLATION:
- For round hole (1-11/32" diameter): Push Bushing section with locking tabs through hole.
- For odd shaped holes: Break off flat washer section from Bushing and insert locking tab section through hole. From opposite side of stud, snap flat washer onto tabbed section.
FEATURES:
- Molded of high strength, non-conductive, polypropylene.
- Mutiple cables may be installed.
- Listed by Underwriters Laboratories.
|
|
